Siemens SINAMICS S Series - r7101[0...99] Par_circuit ring buffer data set number; Ring buffer Ds_No; r7102[0...99] Par_circuit ring buffer fault;alarm received; F;A received; r7103[0...99] Par_circuit ring buffer fault;alarm gone; F;A gone

Parameters
List of parameters
1-894
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Dependency: Refer to: r7101, r7102, r7103
Note: The last fault case that occurred is documented in index 0.
The parameter is reset to 0 at POWER ON.
Description: Ring buffer for faults and alarms that have occurred from power units connected in parallel (Motor Module, Active
Line Infeed, Voltage Sensing Module).
p7101 < 100:
Displays the Power unit Data Set number (PDS).
p7101 >= 100:
Displays the Voltage Sensing Module Data Set number (VSMDS)
Dependency: Refer to: r7100, r7102, r7103
Note: The last fault case that occurred is documented in index 0.
The parameter is reset to 0 at POWER ON.
Description: Ring buffer for faults and alarms that have occurred from power units connected in parallel (Motor Module, Active
Line Infeed, Voltage Sensing Module).
Displays the relative system runtime when the fault or alarm occurred.
Dependency: Refer to: r7100, r7101, r7103
Note: The last fault case that occurred is documented in index 0.
The parameter is reset to 0 at POWER ON.
Description: Ring buffer for faults and alarms that have occurred from power units connected in parallel (Motor Module, Active
Line Infeed, Voltage Sensing Module).
Displays the relative system runtime when the fault or alarm was withdrawn.
Dependency: Refer to: r7100, r7101, r7102
Note: The last fault case that occurred is documented in index 0.
The parameter is reset to 0 at POWER ON.
r7101[0...99] Par_circuit ring buffer data set number / Ring buffer Ds_No
A_INF (Parallel),
B_INF (Parallel),
S_INF (Parallel),
VECTOR (Parallel)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Displays, signals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r7102[0...99] Par_circuit ring buffer fault/alarm received / F/A received
A_INF (Parallel),
B_INF (Parallel),
S_INF (Parallel),
VECTOR (Parallel)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Displays, signals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r7103[0...99] Par_circuit ring buffer fault/alarm gone / F/A gone
A_INF (Parallel),
B_INF (Parallel),
S_INF (Parallel),
VECTOR (Parallel)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Displays, signals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -