List of parameters
Parameters
1-189
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Notice: An ASCII table (excerpt) can be found, for example, in the following List Manual:
Note: The individual characters of the identification number/serial number are available coded as ASCII characters.
Description: Displays the serial number of encoder 3.
Index 0 = first character of the identification number
...
Index x = 20 hex (blank) --> separation between the identification number of serial number
Index x + 1 = 2F hex (slash) --> separation between the identification number of serial number
Index x + 2 = 20 hex (blank) --> separation between the identification number of serial number
Index x + 3 = first character of the serial number
...
Index y with contents = last character of the serial number
Dependency: Refer to: r0460, r0461, r0462, r0463, r0464
Notice: An ASCII table (excerpt) can be found, for example, in the following List Manual:
Note: The individual characters of the identification number/serial number are available coded as ASCII characters.
Description: Displays the position difference before the measuring gearbox between powering-down and powering-up.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Dependency: Refer to: F31501, F32501, F33501
Note: The increments are displayed in the format the same as r0483. The position difference should be read in encoder
increments.
Description: Displays the encoder actual position value Gn_XIST1 according to PROFIdrive for diagnostics. In contrast to
p0482, the value is updated in each DRIVE-CLiQ basic clock cycle and displayed with sign.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
r0467[0...27] Encoder 3 identification number/serial number / Enc3 ID_no/Ser_no
SERVO, VECTOR Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: Encoder Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r0477[0...2] CO: Measuring gearbox, position difference / Meas grbx pos diff
SERVO, VECTOR Can be changed: - Calculated: - Access level: 1
Data type: Integer32 Dynamic index: - Func. diagram: -
P-Group: Encoder Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r0479[0...2] CO: Diagnostics encoder position actual value Gn_XIST1 / Diag Gn_XIST1
SERVO, VECTOR Can be changed: - Calculated: - Access level: 3
Data type: Integer32 Dynamic index: - Func. diagram: -
P-Group: Encoder Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
