Faults and Alarms
Overview of faults and alarms
3-1432
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
3.1.3 Numerical ranges of faults and alarms
Faults and alarms are organized into the following numerical ranges:
Note:
The following numerical ranges for the faults and alarms represent a complete
overview for SINAMICS.
The faults and alarms for the product described in this List Manual are described
in detail in Chapter 3.2.
Table 3-4 Numerical ranges of faults and alarms
from to Range
1000 3999 Control Unit
4000 4999 Reserved
5000 5999 Power unit
6000 6899 Infeed
6900 6999 Braking Module
7000 7999 Drive
8000 8999 Option Board
9000 19999 Reserved
20000 29999 OEM
30000 30999 DRIVE-CLiQ component power unit
31000 31999 DRIVE-CLiQ component encoder 1
32000 32999 DRIVE-CLiQ component encoder 2
Note:
Faults that occur are automatically output as alarm if the
encoder is parameterized as direct measuring system and
does not intervene in the motor control.
33000 33999 DRIVE-CLiQ component encoder 3
Note:
Faults that occur are automatically output as alarm if the
encoder is parameterized as direct measuring system and
does not intervene in the motor control.
34000 34999 Voltage Sensing Module (VSM)
35000 35199 Terminal Module 54F (TM54F)
35200 35999 Terminal Module 31 (TM31)
To Next Page
Loading...
