Siemens SINAMICS S Series - p4041 BI: TM41 signal source for terminal DI;DO 3; TM41 S_src DI;DO 3; p4041 BI: TM15 DI;DO signal source for terminal DI;DO 11; TM15 D S_srcDI;DO11; p4042 BI: TM15 DI;DO signal source for terminal DI;DO 12; TM15 D S_srcDI;DO12; p4043 BI: TM15 DI;DO signal source for terminal DI;DO 13; TM15 D S_srcDI;DO13

List of parameters
Parameters
1-787
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source for terminal DI/DO 3 (X521.4) of terminal module 41 (TM41).
Note: Prerequisite: The DI/DO must be set as an output (p4028.11 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 11 (X521.5) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.11 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 12 (X521.6) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.12 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 13 (X521.7) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.13 = 1).
DI/DO: Bidirectional Digital Input/Output
p4041 BI: TM41 signal source for terminal DI/DO 3 / TM41 S_src DI/DO 3
TM41 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9662
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4041 BI: TM15DI/DO signal source for terminal DI/DO 11 / TM15D S_srcDI/DO11
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9401
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4042 BI: TM15DI/DO signal source for terminal DI/DO 12 / TM15D S_srcDI/DO12
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9401
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4043 BI: TM15DI/DO signal source for terminal DI/DO 13 / TM15D S_srcDI/DO13
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9401
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0