Siemens SINAMICS S Series - r0002 TB30 operating display; TB30 op_display; r0002 DMC operating display; DMC op_display; r0002 TM31 operating display; TM31 op_display

Parameters
List of parameters
1-32
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
46: [46] Power-on inhibit - exit comm mode (p0009, p0010)
60: [60] Infeed de-activated/not operational
250: [250] Device signals a topology error
Dependency: Refer to: r0046
Notice: For several missing enable signals, the corresponding value with the highest number is displayed.
Note: OC: Operating condition
COMM: Commissioning
Description: Operating display for terminal board 30 (TB30).
Values: 0: [00] Module in cyclic operation
40: [40] Module not in cyclic operation
60: [60] Fault
70: [70] Initialization
80: [80] Reset active
120: [120] Module de-activated
250: [250] Device signals a topology error
Notice: For several missing enable signals, the corresponding value with the highest number is displayed.
Description: Operating display for the DRIVE-CLiQ Hub Module Cabinet (DMC).
Values: 0: [00] Module in cyclic operation
40: [40] Module not in cyclic operation
50: [50] Alarm
60: [60] Fault
70: [70] Initialization
120: [120] Module de-activated
250: [250] Device signals a topology error
Notice: For several missing enable signals, the corresponding value with the highest number is displayed.
Description: Operating display for Terminal Module 31 (TM31).
Values: 0: [00] Module in cyclic operation
40: [40] Module not in cyclic operation
50: [50] Alarm
60: [60] Fault
70: [70] Initialization
r0002 TB30 operating display / TB30 op_display
TB30 Can be changed: - Calculated: - Access level: 1
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 250 -
r0002 DMC operating display / DMC op_display
DMC20 Can be changed: - Calculated: - Access level: 1
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 250 -
r0002 TM31 operating display / TM31 op_display
TM31 Can be changed: - Calculated: - Access level: 1
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 250 -