Siemens SINAMICS S Series - p3047 Motor identification - torque characteristic kT5; MotId kT5; p3048 Motor identification - torque characteristic kT7; MotId kT7; p3050[0...n] Motor identification - stator resistance; MotId R_stator; p3054[0...n] Motor identification - rotor resistance; MotId R_rotor

Parameters
List of parameters
1-690
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Dependency: Refer to: p3045, p3047, p3048
Description: Constant kT5 for the torque characteristic set from the motor identification:
kT(iq)=kT1+kT3*iq^2+kT5*iq^4+kT7*iq^6
Dependency: Refer to: p3045, p3046, p3048
Description: Constant kT7 for the torque characteristic set from the motor identification:
kT(iq)=kT1+kT3*iq^2+kT5*iq^4+kT7*iq^6
Dependency: Refer to: p3045, p3046, p3047
Description: Motor stator resistance measured from the motor identification.
Description: Rotor resistance of the motor measured from the motor identification.
Dependency: Refer to: p0625
Note: The parameter is not used for synchronous motors (p0300 = 2xx).
p3047 Motor identification - torque characteristic kT5 / MotId kT5
SERVO (Exp M_ctrl) Can be changed: U, T Calculated: CALC_MOD_ALL Access level: 3
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: ASM, REL, FEM Expert list: 1
Min Max Factory setting
- - -
p3048 Motor identification - torque characteristic kT7 / MotId kT7
SERVO (Exp M_ctrl) Can be changed: U, T Calculated: CALC_MOD_ALL Access level: 3
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: ASM, REL, FEM Expert list: 1
Min Max Factory setting
- - -
p3050[0...n] Motor identification - stator resistance / MotId R_stator
SERVO Can be changed: U, T Calculated: CALC_MOD_ALL Access level: 3
Data type: Floating Point Dynamic index: MDS, p0130 Func. diagram: -
P-Group: Motor identification Units group: 16_1 Unit selection: p0349
Not for motor type: - Expert list: 1
Min Max Factory setting
0.00000 [Ohm] 2000.00000 [Ohm] 0.00000 [Ohm]
p3054[0...n] Motor identification - rotor resistance / MotId R_rotor
SERVO Can be changed: U, T Calculated: CALC_MOD_ALL Access level: 3
Data type: Floating Point Dynamic index: MDS, p0130 Func. diagram: -
P-Group: Motor identification Units group: 16_1 Unit selection: p0349
Not for motor type: PEM, REL Expert list: 1
Min Max Factory setting
0.00000 [Ohm] 300.00000 [Ohm] 0.00000 [Ohm]