Parameters
List of parameters
1-492
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Index: [0] = Harmonics, phase U
[1] = Harmonics, phase V
[2] = Harmonics, phase W
[3] = Measured value phase U
[4] = Measured value phase V
[5] = Measured value phase W
Description: Displays the phase correction voltages and and the drive converter phase voltages
Index: [0] = Harmonics, phase U
[1] = Harmonics, phase V
[2] = Harmonics, phase W
[3] = Measured value phase U
[4] = Meaured value phase V
[5] = Measured value phase W
Description: Sets the motor data identification and speed controller optimization.
p1900 = 0:
Function inhibited.
p1900 = 1:
Induction motors --> set p1910 = 1 and p1960 = 0, 1, 2 depending on p1300
Permanent-magnet or separately-excited synchronous motors --> set p1910 = 1, p1990 = 1 and p1960 = 0, 1, 2
depending on p1300
When the drive enable signals are present, a motor data identification routine is carried out at standstill with the
next power-on command. Current flows through the motor which means that it can align itself by up to a quarter of
a revolution.
For permanent-magnet or separately-excited synchronous motors, the encoder is adjusted with the next power-on
command. The motor must be free to rotate and rotates through 1.5 revolutions of the motor encoder.
With the following power-on command, a rotating motor data identification routine is carried out - and in addition, a
speed controller optimization by making measurements at different motor speeds.
p1900 = 2:
Induction motors --> set p1910 = 1 and p1960 = 0
Permanent-magnet or separately-excited synchronous motors --> set p1910 = 1, p1990 = 1 and p1960 = 0
When the drive enable signals are present, a motor data identification routine is carried out at standstill with the
next power-on command. Current flows through the motor which means that it can align itself by up to a quarter of
a revolution.
For permanent-magnet or separately-excited synchronous motors, the encoder is adjusted with the next power-on
command. The motor must be free to rotate and rotates through 1.5 revolutions of the motor encoder.
Values: 0: Inhibited
1: Motor data identification for rotating motor
2: Motor data identification at standstill
r1849[0...5] Actual value correction phase voltages / ActVal_corr V_corr
VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Modulation Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
p1900 Motor data identification and rotating measurement / Mot ID rot meas
VECTOR Can be changed: C2(1), T Calculated: - Access level: 1
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 2 2
To Next Page
Loading...
