Siemens SINAMICS S Series - r3819.0...7 CO;BO: Sync-line-drive status word; Sync ZSW; p3820[0...n] Friction characteristic, value n0; Friction n0; p3820[0...n] Friction characteristic, value v0; Friction v0; p3821[0...n] Friction characteristic, value n1; Friction n1

List of parameters
Parameters
1-747
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the status word for the line-drive synchronization.
Description: The friction characteristic is defined by 10 value pairs.
This parameter specifies the n coordinate of the 1st value pair of the friction characteristic.
Dependency: Refer to: p3830, p3845
Description: The friction characteristic is defined by 10 value pairs.
This parameter specifies the v coordinate of the 1st value pair of the friction characteristic.
Dependency: Refer to: p3830, p3845
Description: The friction characteristic is defined by 10 value pairs.
This parameter specifies the n coordinate of the 2nd value pair of the friction characteristic.
r3819.0...7 CO/BO: Sync-line-drive status word / Sync ZSW
VECTOR Can be changed: - Calculated: - Access level: 2
Data type: Unsigned32 Dynamic index: - Func. diagram: 7020
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Sync-line-drive enabled Yes No -
02 Sync-line-drive synchronism reached Yes No -
03 Sync-line-drive synchronizing error Yes No -
05 Sync-line-drive frequency measurement
active
Yes No -
06 Sync-line-drive phase control active Yes No -
07 Sync-line-drive without drive Yes No -
p3820[0...n] Friction characteristic, value n0 / Friction n0
SERVO, VECTOR
(n/M)
Can be changed: T Calculated:
CALC_MOD_LIM_REF
Access level: 2
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 7010
P-Group: Functions Units group: 3_1 Unit selection: p0505
Not for motor type: REL Expert list: 1
Min Max Factory setting
0.00 [RPM] 210000.00 [RPM] 15.00 [RPM]
p3820[0...n] Friction characteristic, value v0 / Friction v0
SERVO (Lin) Can be changed: T Calculated:
CALC_MOD_LIM_REF
Access level: 2
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 7010
P-Group: Functions Units group: 4_1 Unit selection: p0505
Not for motor type: REL Expert list: 1
Min Max Factory setting
0.00 [m/min] 21000.00 [m/min] 1.50 [m/min]
p3821[0...n] Friction characteristic, value n1 / Friction n1
SERVO, VECTOR
(n/M)
Can be changed: T Calculated:
CALC_MOD_LIM_REF
Access level: 2
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 7010
P-Group: Functions Units group: 3_1 Unit selection: p0505
Not for motor type: REL Expert list: 1
Min Max Factory setting
0.00 [RPM] 210000.00 [RPM] 30.00 [RPM]