Siemens SINAMICS S Series - p4033 BI: TB30 signal source for terminal DO 3; TB30 S_src DO 3; p4033 BI: TM15 DI;DO signal source for terminal DI;DO 3; TM15 D S_srcDI;DO 3; p4034 BI: TM15 DI;DO signal source for terminal DI;DO 4; TM15 D S_srcDI;DO 4; p4035 BI: TM15 DI;DO signal source for terminal DI;DO 5; TM15 D S_srcDI;DO 5

List of parameters
Parameters
1-783
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source for terminal DO 3 (X481.8) of the Terminal Board 30 (TB30).
Note: DO: Digital Output
Description: Sets the signal source for terminal DI/DO 3 (X520.5) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.3 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 4 (X520.6) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.4 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 5 (X520.7) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.5 = 1).
DI/DO: Bidirectional Digital Input/Output
p4033 BI: TB30 signal source for terminal DO 3 / TB30 S_src DO 3
TB30 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 1790, 9102
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4033 BI: TM15DI/DO signal source for terminal DI/DO 3 / TM15D S_srcDI/DO 3
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9400
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4034 BI: TM15DI/DO signal source for terminal DI/DO 4 / TM15D S_srcDI/DO 4
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9400
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4035 BI: TM15DI/DO signal source for terminal DI/DO 5 / TM15D S_srcDI/DO 5
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9400
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0