Siemens SINAMICS S Series - Page 13

Overview of parameters
Parameters
1-13
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
pxxxx[0...n] Parameter number
The parameter number consists of a "p" or "r", followed by the parameter number
and the index (optional).
Examples of number representation in the parameter list:
Other examples of notation in the documentation:
The following applies to adjustable parameters:
The "shipped" parameter value is specified under "Factory setting" with the rele-
vant unit in square parenthesis. The value can be adjusted within the range
defined by "Min" and "Max".
The term "linked parameterization" is used in cases where changes to adjustable
parameters affect the settings of other parameters.
Linked parameterization can occur, for example, as a result of the following
actions or parameters:
• Execute macros
p0015, p0700, p1000, p1500
• Set PROFIBUS telegram (BICO interconnection)
p0922
• Set component lists
p0230, p0300, p0301, p0400
• Calculate and preset automatically
p0112, p0340, p0578, p3900
• Restore factory settings
p0970
The following applies to display parameters:
The fields "Min", "Max" and "Factory setting" are specified with a dash "-" and the
relevant unit in square parenthesis.
• p... Adjustable parameter (read and write parameter)
• r... Display parameter (read only)
• p0918 Adjustable parameter 918
• p0099[0...3] Adjustable parameter 99, indices 0 to 3
• p1001[0...n] Adjustable parameter 1001, indices 0 to n (n = configurable)
• r0944 Display parameter 944
• p1070[1] Adjustable parameter 1070, index 1
• p2098[1].3 Adjustable parameter 2098, index 1 bit 3
• r0945[2](3) Display parameter 945, index 2 of drive object 3
• p0795.4 Adjustable parameter 795, bit 4
• r2129.0...15 Display parameter 2129 with bit field (maximum 16 bit)