Parameters for data sets
Parameters
1-1077
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
p1576[0...n] Flux boost, adaptation speed, lower / Flux boost n lower
p1577[0...n] Flux boost adaptation speed, upper / Flux boost n upper
p1580[0...n] Efficiency optimization / Efficiency opt.
p1582[0...n] Flux setpoint smoothing time / Flux setp T_smth
p1584[0...n] Field weakening operation, flux setpoint smoothing time / Field weak T_smth
p1585[0...n] Flux actual value, smoothing time / Flux actVal T_smth
p1586[0...n] Field weakening characteristic, scaling / Field weak scal
p1590[0...n] Flux controller P gain / Flux controller Kp
p1592[0...n] Flux controller integral.action time / Flux controller Tn
p1594[0...n] Field-weakening controller, P gain / Field_ctrl Kp
p1596[0...n] Field weakening controller integral-action time / Field_ctrl Tn
p1599[0...n] Flux controller, excitation current difference / Flux ctr I_excDiff
p1600[0...n] P flux controller, P gain / P flux ctrl Kp
p1609[0...n] Current setpoint for I/f operation / I_set I/f oper
p1610[0...n] Torque setpoint static (SLVC) / M_set static
p1611[0...n] Supplementary accelerating torque (SLVC) / M_suppl_accel
p1612[0...n] Current setpoint, open-loop control, sensorless / I_setCtrSensorless
p1616[0...n] Current setpoint smoothing time / I_set T_smooth
p1619[0...n] Setpoint/actual value tracking threshold / SetAct track thrsh
p1620[0...n] Stator current, minimum / I_stator min
p1621[0...n] Changeover speed, inner cos phi = 1 / n_chngov cos phi=1
p1622[0...n] Field-generating current setpoint smoothing time constant / Id_setp T_smth
p1625[0...n] Excitation current setpoint calibration / I_exc_setp cal
p1628[0...n] Current model controller, dynamic factor / I_mod_ctr dyn_fact
p1629[0...n] Current model controller P gain / I_mod_ctrl Kp
p1630[0...n] Current model controller integral time / I_ctrl Tn
p1642[0...n] Minimum excitation current / Min I_exc
p1643[0...n] Gain factor, minimum excitation current closed-loop control / Min I_exc Kp
p1653[0...n] Current setpoint torque-generating minimum smoothing time / Isq_s T_smth_min
p1654[0...n] Curr. setpoint torque-gen. smoothing time field weakening range / Isq_s T_smth FW
p1656[0...n] Activates current setpoint filter / I_set_filt active
p1657[0...n] Current setpoint filter 1 type / I_set_filt 1 Typ
p1658[0...n] Current setpoint filter 1 denominator natural frequency / I_set_filt 1 fn_n
p1659[0...n] Current setpoint filter 1 denominator damping / I_set_filt 1 D_n
p1660[0...n] Current setpoint filter 1 numerator natural frequency / I_set_filt 1 fn_z
p1661[0...n] Current setpoint filter 1 numerator damping / I_set_filt 1 D_z
p1662[0...n] Current setpoint filter 2 type / I_set_filt 2 Typ
p1663[0...n] Current setpoint filter 2 denominator natural frequency / I_set_filt 2 fn_n
p1664[0...n] Current setpoint filter 2 denominator damping / I_set_filt 2 D_n
p1665[0...n] Current setpoint filter 2 numerator natural frequency / I_set_filt 2 fn_z
p1666[0...n] Current setpoint filter 2 numerator damping / I_set_filt 2 D_z
p1667[0...n] Current setpoint filter 3 type / I_set_filt 3 Typ
p1668[0...n] Current setpoint filter 3 denominator natural frequency / I_set_filt 3 fn_n
p1669[0...n] Current setpoint filter 3 denominator damping / I_set_filt 3 D_n
p1670[0...n] Current setpoint filter 3 numerator natural frequency / I_set_filt 3 fn_z
p1671[0...n] Current setpoint filter 3 numerator damping / I_set_filt 3 D_z
p1672[0...n] Current setpoint filter 4 type / I_set_filt 4 Typ
p1673[0...n] Current setpoint filter 4 denominator natural frequency / I_set_filt 4 fn_n
p1674[0...n] Current setpoint filter 4 denominator damping / I_set_filt 4 D_n
p1675[0...n] Current setpoint filter 4 numerator natural frequency / I_set_filt 4 fn_n
p1676[0...n] Current setpoint filter 4 numerator damping / I_set_filt 4 D_z
p1701[0...n] Current controller reference model dead time / I_ctrRefMod t_dead
p1702[0...n] Isd current controller pre-control scaling / Isd_ctr_prectrScal
To Next Page
Loading...
