Overview of parameters
Parameters
1-25
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Parameter values
Not for motor type
Specifies for which motor type this parameter has no significance.
ASM: Induction motor
FEM: Separately excited synchronous motor
PEM: Permanently excited synchronous motor
REL: Reluctance motor/SIEMOSYN-Motor
Expert List
Specifies whether this parameter is available in the expert list of the specified
drive objects in the commissioning software.
1: Parameter does exist in the expert list.
0: Parameter does not exist in the expert list.
Min Minimum value of the parameter [unit]
Max Maximum value of the parameter [unit]
Factory setting Shipped value (default) [unit]
A different value may be displayed for certain parameters
(e.g. p1800) at the initial commissioning stage.
Reason:
The setting of these parameters is determined by the
operating environment of the Control Unit (e.g.depending
on converter type, macro, Power Module).
Note:
For SINAMICS G150/G130/S150, the macros and their settings are provided in
the following documentation:
References: /BAx/ x = 1, 2, 3
SINAMICS G150/G130/S150 Operating Instructions
Notice:
The user shall assume full responsibility for using parameters marked
"Expert list: 0" (Parameter does not exist in the expert list).
These parameters and their functionalities have not been tested and no further
user documentation is available for them (e.g. function description). Moreover no
support is ensured for these parameters by "Technical Support" (hotline).
To Next Page
Loading...
