Siemens SINAMICS S Series - Page 1797

Index
D-1797
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
4711
Speed actual value sensing, encoder 2, 3
(r0108.7 = 1, APC activated), 2-1261
4715
Speed act
Ebene 3 value and pole pos. sensing,
motor enc. ASM/SM (encoder 1),
2-1262
4720
Encoder interface, receive signals,
encoders 1 ... 3, 2-1263
4730
Encoder interface, send signals,
encoders 1 ... 3, 2-1264
4735
Reference mark search with
equivalent zero mark, encoders 1 ... 3,
2-1265
4740
Measuring probe evaluation, measured
value memory, encoders 1 ... 3,
2-1266
5020
Speed setpoint filter and
speed pre-control, 2-1268
5030
Reference model/pre-control balan-
cing/speed limiting, 2-1269
5040
Speed controller with encoder, 2-1270
5042
Speed controller, torque-speed pre-cont-
rol with encoder (p1402 = 1), 2-1271
5050
Kp_n-/Tn_n adaptation, 2-1272
5060
Torque setpoint,
changeover control type, 2-1273
5210
Speed controller without encoder, 2-1274
5300
V/f control for diagnostics, 2-1275
5490
Speed control configuration, 2-1276
5610
Torque limiting/reduction/interpolator,
2-1277
5620
Motor/generator torque limit, 2-1278
5630
Upper/lower torque limit, 2-1279
5640
Mode changeover,
power/current limiting, 2-1280
5650
Vdc_max controller and
Vdc_min controller, 2-1281
5710
Current setpoint filter, 2-1282
5714
Iq and Id controller, 2-1283
5722
Field current input, flux controller, 2-1284
5730
Interface to the Motor Module
(control signals, current actual values),
2-1285
6030
Speed setpoint, droop, 2-1287
6031
Pre-control balancing reference/accelera-
tion model, 2-1288
6040
Speed controller with / without encoder,
2-1289
6050
Kp_n-/Tn_n adaptation, 2-1290
6060
Torque setpoint, 2-1291
6220
Vdc_max controller and
Vdc_min controller, 2-1292
6300
V/f characteristic and voltage boost,
2-1293
6310
Resonance damping and slip compensati-
on, 2-1294
6320
Vdc_max controller and
Vdc_min controller, 2-1295
6490
Speed control configuration, 2-1296
6491
Flux control configuration, 2-1297
6495
Excitation (FEM, p0300 = 5), 2-1298
6630
Upper/lower torque limit, 2-1299
6640
Current/power/torque limits, 2-1300
6710
Current setpoint filter, 2-1301