Siemens SINAMICS S Series - Page 1798

Index
D-1798
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
6714
Iq and Id controller, 2-1302
6721
Id setpoint (PEM, p0300 = 2), 2-1303
6722
Field weakening characteristic, Id setpoint
(ASM, p0300 = 1), 2-1304
6723
Field weakening controller, flux controller
(ASM, p0300 = 1), 2-1305
6724
Field weakening controller (PEM,
p0300 = 2), 2-1306
6725
Flux setpoint, field weakening controller
(FEM, p0300 = 5), 2-1307
6726
Field weakening controller, flux controller
(FEM, p0300 = 5), 2-1308
6727
Current model, excitation current monito-
ring, control cos phi (FEM, p0300 = 5),
2-1309
6730
Interface to Motor Module (ASM,
p0300 = 1), 2-1310
6731
Interface to the Motor Module (PEM,
p0300 = 2), 2-1311
6732
Interface to Motor Module (FEM,
p0300 = 5), 2-1312
6799
Display signals, 2-1313
7008
kT estimator, 2-1315
7010
Friction characteristic, 2-1316
7012
Advanced Positioning Control (APC,
r0108 = 1), 2-1317
7014
External armature short circuit (EASC,
p0300 = 2xx or 4xx), 2-1318
7016
Internal armature short circuit (IASC,
p0300 = 2xx or 4xx), 2-1319
7017
DC injection brake (p0300 = 1xx), 2-1320
7020
Synchronization, 2-1321
7950
Fixed values (r0108.16 = 1), 2-1323
7954
Motorized potentiometer (r0108.16 = 1),
2-1324
7958
Closed-loop control (r0108.16 = 1),
2-1325
8010
Speed signals, 2-1327
8012
Torque signals, motor locked/stalled,
2-1328
8013
Load monitoring (r0108.17 = 1), 2-1329
8014
Thermal monitoring, power unit, 2-1330
8016
Thermal monitoring motor, 2-1331
8018
Separately excited synchronous motor
(FEM, p0300 = 5), 2-1332
8060
Fault buffer, 2-1334
8065
Alarm buffer, 2-1335
8070
Fault/alarm trigger word (r2129), 2-1336
8075
Fault/alarm configuration, 2-1337
8134
Measuring sockets, 2-1339
8560
Command Data Sets (CDS), 2-1341
8565
Drive Data Sets (DDS), 2-1342
8570
Encoder Data Sets (EDS), 2-1343
8575
Motor Data Sets (MDS), 2-1344
8580
Power unit Data Set, PDS, 2-1345
8720
Control word
sequence control infeed, 2-1347
8726
Status word
sequence control infeed, 2-1348
8732
Sequencer, 2-1349
8734
Missing enable signals, line contactor
control, 2-1350