Siemens SINAMICS S Series - Page 21

Overview of parameters
Parameters
1-21
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Dynamic index
For parameters with a dynamic index [0...n], the following information is specified
here:
• Data set (if this is available).
• Parameter for the number of indices (n = number - 1).
The following information can be contained in this field:
• "CDS, p0170" (Command Data Set, CDS count)
Example:
p1070[0] Æ main setpoint [command data set 0]
p1070[1] Æ main setpoint [command data set 1], etc.
• "DDS, p0180" (Drive Data Set, DDS count)
• "EDS, p0140" (Encoder Data Set, EDS count)
• "MDS, p0130" (Motor Data Set, MDS count)
• "PDS, p0120" (Power unit Data Set, PDS count)
• "p2615" (traversing blocks count)
BO: Integer32 – – – x
BO: FloatingPoint32––––
Legend:
x: BICO interconnection permitted
–: BICO interconnection not permitted
1 Exception:
BICO input parameters with data type "Unsigned32 / FloatingPoint32" can also be interconnected with the following
BICO output parameters although these are not of the "FloatingPoint32" data type:
CO: r8850
CO: r8860
CO: r2050
CO: r2060
Table 1-2 Possible combinations of BICO interconnections, continued
BICO input parameter
CI parameter BI parameter
BICO output parameter Unsigned32 /
Integer16
Unsigned32 /
Integer32
Unsigned32 /
FloatingPoint32
Unsigned32 /
Binary
Note:
Information on the data sets can be taken from the following references:
References: /FH1/ SINAMICS S120 Function Manual Drive Functions
Section "Data sets"