www.ti.com
Touchscreen Controller Registers
12.5.1.7 IRQWAKEUP Register (offset = 34h) [reset = 0h]
IRQWAKEUP is shown in Figure 12-11 and described in Table 12-11.
IRQ wakeup enable
Figure 12-11. IRQWAKEUP Register
31 30 29 28 27 26 25 24
Reserved
R/W-0h
23 22 21 20 19 18 17 16
Reserved
R/W-0h
15 14 13 12 11 10 9 8
Reserved
R/W-0h
7 6 5 4 3 2 1 0
Reserved WAKEEN0
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; R = Read only; W1toCl = Write 1 to clear bit; -n = value after reset
Table 12-11. IRQWAKEUP Register Field Descriptions
Bit Field Type Reset Description
31-1 Reserved R/W 0h
0 WAKEEN0 R/W 0h Wakeup generation for HW Pen event.
0 = Wakeup disabled.
1 = Wakeup enabled.
1045
SPRUH73H–October 2011–Revised April 2013 Touchscreen Controller
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
To Next Page
Loading...
