www.ti.com
GPIO Registers
25.4.1.21 GPIO_RISINGDETECT Register (offset = 148h) [reset = 0h]
GPIO_RISINGDETECT is shown in Figure 25-27 and described in Table 25-26.
The GPIO_RISINGDETECT register is used to enable/disable for each input lines the rising-edge
(transition 0 to 1) detection to be used for the interrupt request generation.
Figure 25-27. GPIO_RISINGDETECT Register
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
RISINGDETECT[n]
R/W-0h
LEGEND: R/W = Read/Write; R = Read only; W1toCl = Write 1 to clear bit; -n = value after reset
Table 25-26. GPIO_RISINGDETECT Register Field Descriptions
Bit Field Type Reset Description
31-0 RISINGDETECT[n] R/W 0h
Rising Edge Interrupt Enable
0x0 = Disable IRQ on rising-edge detect.
0x1 = Enable IRQ on rising-edge detect.
4089
SPRUH73H–October 2011–Revised April 2013 General-Purpose Input/Output
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
To Next Page
Loading...
