www.ti.com
CONTROL_MODULE Registers
9.3.75 reset_iso Register (offset = 1000h) [reset = 0h]
reset_iso is shown in Figure 9-78 and described in Table 9-85.
Figure 9-78. reset_iso Register
31 30 29 28 27 26 25 24
Reserved
R-0h
23 22 21 20 19 18 17 16
Reserved
R-0h
15 14 13 12 11 10 9 8
Reserved
R-0h
7 6 5 4 3 2 1 0
Reserved iso_control
R-0h R/W-0h
LEGEND: R/W = Read/Write; R = Read only; W1toCl = Write 1 to clear bit; -n = value after reset
Table 9-85. reset_iso Register Field Descriptions
Bit Field Type Reset Description
31-1 Reserved R 0h
0 iso_control R/W 0h 0 : Ethernet Switch is not isolated
1 : Ethernet Switch is isolated
839
SPRUH73H–October 2011–Revised April 2013 Control Module
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
To Next Page
Loading...
