RTC_SS
www.ti.com
20.3.5.22 RTC_SCRATCH2_REG Register (offset = 68h) [reset = 0h]
RTC_SCRATCH2_REG is shown in Figure 20-82 and described in Table 20-85.
The RTC_SCRATCH2_REG is used to hold some required values for the RTC register.
Figure 20-82. RTC_SCRATCH2_REG Register
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
RTCSCRATCH2
R/W-0h
LEGEND: R/W = Read/Write; R = Read only; W1toCl = Write 1 to clear bit; -n = value after reset
Table 20-85. RTC_SCRATCH2_REG Register Field Descriptions
Bit Field Type Reset Description
31-0 RTCSCRATCH2 R/W 0h
Scratch registers, available to program
3656
Timers SPRUH73H–October 2011–Revised April 2013
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
To Next Page
Loading...
Need help?
General
