Interrupt Controller Registers
www.ti.com
6.5.1.23 INTC_MIR_SET1 Register (offset = ACh) [reset = 0h]
INTC_MIR_SET1 is shown in Figure 6-26 and described in Table 6-26.
This register is used to set the interrupt mask bits.
Figure 6-26. INTC_MIR_SET1 Register
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
MirSet
W-0h
LEGEND: R/W = Read/Write; R = Read only; W1toCl = Write 1 to clear bit; -n = value after reset
Table 6-26. INTC_MIR_SET1 Register Field Descriptions
Bit Field Type Reset Description
31-0 MirSet W 0h
Write 1 sets the mask bit to 1, reads return 0
228
Interrupts SPRUH73H–October 2011–Revised April 2013
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
To Next Page
Loading...
Need help?
General
