Texas Instruments AM335 Series

www.ti.com USB Registers
Table 16-146. RX_CALIB Register Field Descriptions (continued)
Bit Field Type Reset Description
1 SQ_CAL_DONE R 0h Sq calibration is done when this bit = 1.
see RESTART_SQ_CAL for more description.Read value is valid
only if VDDLDO is on.
0 RESTART_SQ_CAL R/W 0h the squelch calibration continuously goes through restart cycles
when this bit is 1 .
i.e.
restarts waits for done then restarts again etc.
1905
SPRUH73H–October 2011–Revised April 2013 Universal Serial Bus (USB)
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated